The TOSduino Uno R3 requires the Arduino 1.0 drivers folder in order to install properly on some computers. We have tested and confirmed that the R3 can be programmed in older versions of the IDE. However, the first time using the R3 on a new computer, you will need to have Arduino 1.0 installed on that machine.
The small chip is ATmega16U2, the 28 pin DIP socket chip is ATmega328-pu.
Cathal Keady's question:
Can item SKU066313 be powered directly from using the USB port or do I need to purchase a power supply for it.
This item has not built-in battery, so it can not be charged. With that USB cable connect to computer, you can use it. There is no need of power supply.
2.4 Inch TFT LCD Touch Screen Module:
2.4 inch LCD TFT display
Bright, 4 white-LED backlight, on by default but you can connect the transistor to a digital pin for backlight control
Colorful, 18-bit 262,000 different shades
4-wire resistive touchscreen
240 x 320 resolution
Spfd5408 controller with built in video RAM buffer
8 bit digital interface, plus 4 control lines
Uses digital pins 5-13 and analog 0-3. That means you can use digital pins 2, 3 and analog 4 and 5. Pin 12 is available if not using the micro SD
5V compatible, use with 3.3V or 5V logic
Size: 71 x 52 x 7mm
1 x UNO R3 ATmega328P Board with USB
1 x 2.4 Inch TFT LCD Touch Screen Module